Lake St. Clair Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
19,233 Posts
QUOTE(hammer @ Sep 26 2003, 09:22 PM)DON'T use red pop in your motors. Get the blue ENGINE stuff (Dynamic Speed & marine 949-5990) It is enviromentally safe when you start them in the spring. I NEVER pumped it through the outdrives always took off the thermostat housing and poured it in there or later on pulled off one of the big hoses off the water pump and poured it through there. Haven't done it in five years as my Horizons have closed cooling. Once you drain the motors, hoses, exhaust manifolds, lake water pump, AND the oil cooler hiding under the motor, one gallon per motor is enough. After I drained the motors I used to turn the motors over a couple times (don't start) there is still a lot of water in the lake water pump and hoses that will drain out the block also. I'll give you a hand if you need it Jim. Bring beer.

God, we did ours tonight....pain in the arse I tell ya.....Go blue! Cheaper to buy the blue than have a cracked engine in the Spring.
 

·
Registered
Joined
·
19,233 Posts
QUOTE(hammer @ Sep 27 2003, 11:20 AM)What do chicks know? I think 3crabs did the work.

After that statement I would say we are even!


By the way, this chick is right there for the dirty deed
Somebody has to supervise
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top