Lake St. Clair Fishing Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
12,052 Posts
If its been on a long time, go to a paint supply store and get the rubber wheel for a drill motor. It rubs the vinyl off and doesn't hurt the gelcoat.
 

·
Registered
Joined
·
585 Posts
Discussion Starter · #6 ·
WooHooo...it worked!

Hair dryer and alot of time and patience, but it all came off except for a little bit of glue which came off with some softscrub. Cant even tell anything was there, no fading at all.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top